![]() So, if my geometry is far enough away from the origin, I have to zoom way out after creating the block just to be able to see where it is and be able to locate it with a final left click. It's not AT the origin, it's at a certain distance away from the crosshair. how do I explain this? It's the same distance from the crosshairs as the origin was when the block was created. The resulting block always has an insertion point of. So, I orient the camera, and use the FLATSHOT command. Say I have some geometry that I want a 2D block of. Sorry if I'm missing a thread and this is a duplicate. here you can turn that automatic scaling off and then insert your geometry from the other drawing, hopefully that helps.īe careful: this -DWGUNITS setting to ignore units-scaling should not be deactivated by default.īesides of your base drawing it might also be interesting to get the drawing that was your result after you did the copy & paste or insert.I'm going to sound dumb here, but I can't figure this one out using the normal Googly avenues. To make sure that the units setting is ignored when you insert new geometry you can use command -DWGUNITS, one of the last questions is if inserted geometry should be scaled by units. and as not all your block-insertions are inserted at 0,0,0 the complete pasted geometry (into other units) seems to be something like exploded into all directions (exploded is not meant as AutoCAD's _EXPLODE). As you see the block-unit is "Inches", if you insert that geometry into a drawing with different units-setting the complete geometry gets scaled (that nothing new, that's what units make), but in this drawing the block will not be just scaled around it's geometry position, it gets scaled based on a point that is far away from the geometry. That happens often when you get drawing files (DXF or DWG) created from a converter (from CAD systems working different to AutoCAD's block technology). Or with other words: the block-insertion has it's insertion-point far away from it's geometry. The geometry of the block definition is far away from it's base-point. Well, you do have a lot of block-definitions which are created in a (for AutoCAD) very unusual way. > I uploaded his document if you have time to give it a crack! This is only a problem copying from 1 to 2, not 2 to 1. The objects appears to "start" pasting (b/c prompts come up making sure I'll accept the educational stamp). I paste into Drawing 2 using any number of commands. To recap: I copy something from Drawing 1. (I can draw on Drawing2.dwg and save without problem as well.) Drawing 2 is opened as a template, and displays on my monitor as Drawing2.dwg. When I zoom extents, the drawing "zooms" around a handful of template components I have drawn (scale bars, figures, labels, etc.) So it would seem that nothing is getting copied from Drawing 1 at all.ĮDIT: I CAN copy from Drawing 2 into Drawing 1 with no problem using any of the methods described above. All the layers are on (unfrozen, lightbulbs "lit," etc.). ![]() DO YOU WISH TO CONTINUE? (I click continue)Īfter this, nothing shows up. ![]() ![]() AN EDUCATIONAL PLOT STAMP WILL BE ADDED TO YOUR DRAWING.ETC.) DO YOU WISH TO CONTINUE? (I click continue) THIS DRAWING WAS PRODUCED BY AN EDUCATION PRODUCT (ETC.In all of these cases, I can successfully begin the pasting into DRAWING 2. (The circle w a slash symbol comes up, I believe because Drawing 1 was created in an educational version.) Tiling Drawings 1 and 2, and dragging the objects from Drawing 1 to Drawing 2.Creating a block with the objects using the WBlock command and inserting that.I want to copy and paste a ground plan from one document (created by someone else on an educational version of cad) to another (AutoCAD Architecture 2014) and it's not working. ![]()
0 Comments
Leave a Reply. |